Publicité
Les langues disponibles
Les langues disponibles
In order to protect the user, take precautions.
If the mains cable gets damaged or cut during the use, do not
touch it, but instantly pull the plug out of the socket. Never use
the tool with damaged mains cable.
The tool must neither be wet nor used in humid environment.
Do not use the tool in an environment with danger of explosion.
Do not drill into asbestos-containing materials.
Modifications of the tool are prohibited.
Always check the tool, cable and plug before use and plug before use.
Have damages only repaired by specialists.
Insert the plug into the socket only when the tool switch is off.
When you work outside, the machine has to be used with a fault-current
circuit breaker with max. 30 mA.
The machine should only work under supervision of somebody.
Plug and switch the machine off if it is not under supervision, in case of
putting up and stripping down the machine, in case of voltage drop or
when fixing or mounting an accessory.
Switch the machine off if it stops for whatever reason. You avoid that it
starts suddenly and not under supervision.
Don't use the machine if a part of the housing is damaged or in case of
damages on the switch, the cable or plug.
Check the accessories before use. Do not use any products which are
broken, cracked or damaged in another way.
Before use, make sure that the tool is correctly fixed and fastened.
Let it run idle for about 30 seconds in a safe position. If considerable
vibrations occur or if other defects are recognised, switch off
immediately.
Always lead the mains and extension cable as well as the extraction
hose to the back away from the machine.
Hold the power tool only by the insulated gripping surfaces when
performing an operation where the cutting tool may contact hidden
wiring or its own cord. Contact with a "live" wire will also make exposed
metal parts of the power tool "live" and shock the operator.
When working with the machine, always hold it firmly with both hands
and provide for a secure stance. The power tool is guided more secure
with both hands.
Secure the workpiece. A workpiece clamped with clamping devices or in
a vice is held more secure than by hand.
When the cut is completed, switch off the machine and then pull the saw
blade out of the cut only after it has come to a standstill. In this manner
you can avoid kickback and can place down the machine securely.
15
Publicité
