Technical Speciications; Technical Specifications - eKey TOCAhome Mode D'emploi

Technical Speciications

Problem
An enrolled inger
cannot be identiied.
Status point of the control
panel is not blinking.
Error code "E0"
visible in the display fol-
lowed by the count-down
starting from 45.
Error code "E1"
visible in the display.
Error code "E2"
visible in the display
The LED on the scanner
tiication, however the relay is signalling a positive iden-
is not released

6. TECHNICAL SPECIFICATIONS

• CONNECTIONS
o Connection between scanner and control panel
o 1x Relay 250VAC 5A (3x ekey
o 9VAC with provided external power supply unit
• MEMORY
o 99 ingers possible
o No loss of data after power failure
26
Cause
ferent area of the inger was
1. During enrolment, a dif-
scanned.
2. The enrolment has not
been carried out correctly.
System not connected
to the power supply.
1. Connection between the
scanner and control panel is
not correct.
2. The power supply has been
>
interrupted the system is
starting again.
99 ingers have already been
enrol more ingers. enrolled. It is not possible to
Incorrect security code has
been entered three times.
The inger is not accepted,
Wrong unit coupling.
as a device has been swapped
®
TOCAhome 3 and PC model)
Solution
1. The inger has to be enrolled
again by swiping it consistently
over the sensor.
inger" – perfect enrolment en-
2. See "I am unable to enrol a
sures high identiication rates.
1. Ensure power supply
2. Inspect glass tube fuse
1. Check the "4-line"
connection wire.
2. Wait until the system has
initialised again.
Erase some ingers
in order to enrol new ones.
Wait for 30 min, enter
the correct security code.
After swapping
scanner or control panel,
a reset has to be carried out.