Recording A Finger With The Sensor - eKey TOCAhome Mode D'emploi

Operation
4.4. RECORDING A FINGER WITH THE SENSOR (SEE FIGURE 4)
It is important that the user draw his/her inger correctly across the sensor.
Note: The best results are achieved by using the middle inger while spreading the pointer
and ring ingers away from the middle inger.
Place the entire surface of the desired inger
The larger the surface area of the inger, the higher the probability will be that the inger is
recognised by the device the next time it is placed on the sensor.
The sensor is located between the two arrow indicators illuminated in green.
the right pressure (not too hard and not too soft) and drag the inger across the sensor at
Manual workers should be aware that their inger lines are likely to wear
medium speed.
off, which means that a right-handed worker should record ingers on his/her left hand and
vice versa.
ATTENTION:
Please swipe the largest possible inger surface, starting from the irst inger joint
and applying gentle pressure. The larger the scanned inger surface, the easier it
will be for the inger to be recognised.
4.5. HOW TO ENROL A FINGER
1. ENTERING THE SECURITY CODE
1.1. Press the OK-key in the control panel.
1.2. Enter the irst digit of the security code using < and > (standard setting is 9)
1.3. Press the OK-key.
1.4. Enter the second digit of the security code using < and > (standard setting is 9)
1.5. Press the OK-key.
1.6. In the display "Eu" (enrol user) is visible.
2. SETTING ACCESS AUTHORITIES
2.1. If "Eu" is visible in the display of the control panel, press the OK-key.
2.2. Setting user number: The display shows "1". If the user ID is already taken, a red
dot appears in the lower right hand corner of the display. Example: "1." Select a user
ID by using the < and > keys.
2.3. Press the OK-key.
22
after the last joint onto the sensor.
Apply just