Trouble Shooting - eKey TOCAhome Mode D'emploi

Trouble Shooting

1. ENTERING THE CURRENT SECURITY CODE
1.1. Press the OK-key in the control panel.
1.2. Enter the irst digit of the security code using < and > (standard setting is 9)
1.3. Press the OK-key.
1.4. Enter the second digit of the security code using < and > (standard setting is 9)
1.5. Press the OK-key.
1.6. In the display "Eu" (enrol user) is visible.
2. RESETTING TO INITIAL STANDARD SETTING
Press the >-key until "sc" is visible in the display of the control panel.
2.1.
2.2. Press the OK-key.
2.3. Enter the irst digit of the security code using < and > (standard setting is 9)
2.4. Press the OK-key.
2.5. Enter the second digit of the security code using < and > (standard setting is 9)
2.6. Press the OK-key.
2.7. In the display of the control panel, "OK" will be visible for a short moment and two
red dots will appear. The system has been rest to initial standard setting.
5. TROUBLE SHOOTING
Problem
I am unable to enrol a inger.
Cause
1. The inger has not been
sensor, starting from the irst
swiped consistently over the
inger joint.
2. The inger has been swiped
too softly or too strongly over
the sensor.
3. The inger has been swiped
too fast or too slowly over the
sensor.
Solution
1. Swipe the inger consistently
the irst inger joint.
over the sensor starting from
2. Swipe the inger gently, but
not too softly over the sensor.
3. Swipe the inger with mode-
rate speed over the sensor.
25