eKey TOCAhome Mode D'emploi page 27

Operation
2.4. Setting inger number: The display shows "F1". F1 stands for inger 1.
Start counting your ingers from the little inger of the left hand.
The little inger of your right hand would then be number 10 (setting "F0"
in the display) e.g. "F7" would be the index inger of your right hand.
If a inger ID is already in use a red dot appears in the lower right hand corner of the
display.
2.5. Press the OK-key.
TOCAhome, the display shows "EF" (enrol finger), as the control
®
2.6. For ekey
panel is equipped with 1 relay.
®
2.7. For ekey TOCAhome 3 and ekey
to be activated by the selected finger.
Entering relay: "o1" is visible in the display of the control panel.
Select the desired relay by using the keys < or > and press the OK key.
Now "EF" will appear in the display.
3. ENROLLING FINGER
3.1. Once "EF" (enrol inger) is visible in the display of the control panel, you have 60
seconds to swipe your inger over the sensor, starting from the irst inger joint.
3.2. The enrolment should be done as described in chapter 4.4.
3.3. The scanner is equipped with a status display (LED), which indicates the opera-
ting mode:
Red: The inger could not be scanned successfully ;
please try again!
Orange: The device is waiting for a inger to be scanned.
Green: Successful scan
4.6. DELETING A USER FROM THE SYSTEM
1. ENTERING THE SECURITY CODE
1.1. Press the OK-key in the control panel.
1.2. Enter the irst digit of the security code using < and > (standard setting is 9)
1.3. Press the OK-key.
1.4. Enter the second digit of the security code using < and > (standard setting is 9)
1.5. Press the OK-key.
1.6. In the display "Eu" (enrol user) is visible.
®
TOCAhome pc, you can now select the relay
23