eKey TOCAhome Mode D'emploi page 28

Operation
2. DELETING A USER
Press the >-key until "du" (delete user) is visible in the display of the control panel.
2.1.
2.2. Press the OK-key.
2.3. Press the < or >-key to select the user ID to be deleted from the system.
2.4. Conirm the user ID to be deleted by pressing the OK-key.
2.5. In the display of the control panel, "OK" will be visible for a short moment and the
system will return to the standard operating mode.
4.7. CHANGING THE SECURITY CODE
Please note that without the security code you are unable to operate the system. If the
wrong security code is entered 3 times, the system will be disabled for 30 minutes.
1. ENTERING THE CURRENT SECURITY CODE
1.1. Press the OK-key in the control panel.
1.2. Enter the irst digit of the security code using < and > (standard setting is 9)
1.3. Press the OK-key.
1.4. Enter the second digit of the security code using < and > (standard setting is 9)
1.5. Press the OK-key.
1.6. In the display "Eu" (enrol user) is visible.
2. DEFINING A NEW SECURITY CODE
Press the >-key until "sc" is visible in the display of the control panel.
2.1.
2.2. Press the OK-key.
2.3. Enter the new irst digit of the security code using < and >.
2.4. Press the OK-key.
2.5. Enter the second digit of the security code using < and >
2.6. Press the OK-key.
2.7. In the display of the control panel, "OK" will be visible for a short moment and the
system will return to the standard operating mode.
4.8. RESETTING TO FACTORY SETTINGS
When resetting the system to the initial factory settings, all data from the system is
deleted. The security code is reset to the factory default "99" and the scanner and
control panel loose their coupling.
24