Connections - Fronius TransPocket 4000 CEL Instructions De Service

(11)
(12)

Connections

Front and rear view of TP 4000 CEL / TP 5000 CEL
power source
When using the TR 3000 remote control, always connect the rod electrode cable to the
(+) current socket.
(3)
(4)
(5)
(6)
(7)
Overtemperature indicator
Lights up if the power source overheats (e.g. because the duty cycle has been
exceeded). For more information on this, see the "Troubleshooting" section.
TP 08 indicator
Lights up when a TP 08 remote control is connected to the power source.
Even if the TP 08 remote control has already been disconnected, the TP 08 indi-
cator remains lit. As long as the TP 08 indicator is lit, current and arc-force dyna-
mic can only be set on the TP 08 remote control.
To restore the current and arc-force dynamic setting option on the power source
and other system add-ons:
1. Disconnect TP 08
2. Switch the power source off and back on again
3. TP 08 indicator does not light up
(5)
(6)
(1) (2) (3) (4)
Blanking cover
Blanking cover
Blanking cover (reserved for LocalNet connection)
Blanking cover (reserved for LocalNet connection)
Mains cable with strain relief device
(1) (-) current socket with bayonet
latch for:
- Connecting the rod electrode
cable or grounding cable
during manual metal arc wel-
ding (depending on the type of
electrode)
- Current connection of the TIG
welding torch
(2) (+) current socket with bayonet
latch for:
- Connecting the rod electrode
(7)
cable and grounding cable
during manual metal arc wel-
ding (depending on the type of
electrode)
- Connecting the grounding
cable in TIG welding
73