Operating The Handle - Fronius TransPocket 4000 CEL Instructions De Service

(10)
(10)
Secure the handle plates and the handle tube using
"Extrude-Tite" screws
3
IMPORTANT! To secure the two handle plates (1) in the centre, place two Extrude-Tite
screws on one side (9) and two Extrude-Tite screws on the other side (10), so that the
screw heads are each on the side with the larger hole.
4
Operating the IMPORTANT! When the handle (1) is retracted, it is essential to lock the handle by tur-
handle ning it to the left.
1
Extend the handle
84
(3) (4) (1) (5)
(9)
(9)
Secure the handle plates (1) to the top using four Extrude-Tite screws (5) and (7)
Secure the handle plates (1) together in the centre using four Extrude-Tite screws (9)
and (10)
To retract the handle (1):
- Turn the handle to the left (unlock)
- Turn the handle to the left again (lock)
(1)
1
(6) (7) (8)
2
IMPORTANT! To fix the handle plates (1)
on the top, place two Extrude-Tite screws
on one side (5) and two Extrude-Tite
screws on the other side (7), so that the
screw heads are each on the side with the
larger hole.
IMPORTANT! When the handle (1) is
extended, it is essential to lock the handle
by turning it to the right.
2
Allow the handle plates (1) to engage
on the power source handle (4) using
the locking devices (2)
Insert the cotter pin (8) of the handle
tube (3) into the guides (6) of both
handle plates
To extend the handle (1):
- Turn the handle to the right
(unlock)
- Pull the handle out as far as it will
go
- Turn the handle to the right again
(lock)