Startup Stage - Last Calor VIOLA 2014 Manuel D'installation, D'utilisation Et D'entretien

The Figure opposite describes the meaning of the status indicators in the left
part of the display.
Activation of one of the segments on the display signals activation of the
corresponding device according to the list opposite.
4.3 Lighting
4.3.1Check before lighting
Before lighting the stove:
- make sure you have read and understood that given in the manual;
- the hopper must be filled with pellets;
- the combustion chamber must be clean;
- the brazier must be completely free, cleaned of any combustion residuals and correctly fitted in the brazier
holder;
- check hermetic closing of the fire door and ash pan;
- check the connection of the power cable and switching to ON/1 of the switch located on the back of the stove.
- At first startup, remove all the components (instructions/label) that could burn from the stove firebox
and glass.
- Any lightings done after long stove idle periods require the renewal of any pellets that have been inside
the hopper for a long time, in being a damp fuel no longer suitable for combustion, and complete
cleaning of the combustion chamber.

4.3.2 Startup stage

To light the stove, press the button 'P4' for 3 seconds: the message 'START' will appear on the display.
The stage is automatic and managed entirely by the electronic controller without the possibility of changing the
parameters.
The stove carries out the startup stages in sequence according to the procedures defined by the parameters that
manage levels and times, reaching the work condition unless anomalies or alarms occur, according to the following
table:
Clock
Output
Dialogue box
Room temperature
Button 'P4'
41
external contact
chrono
igniter
auger
fume extractor
exchanger
not used
alarm
VIOLA 2014