Installing The Drive - Sony DVCAM DRV-1000 Mode D'emploi

Installation

Installing the drive

10 EN
WARNING: Before you start, check that the computer is
completely disconnected from the AC supply and any other
devices.
Use the following procedure.
1
1
Remove the cover from the computer.
2
Remove the blanking panel from the 5-1/4-inch bay in
which you are going to install the drive.
3
Slide the drive carefully into the bay.
4
Use the four supplied screws to fasten the drive in place.
Note
Use only the supplied screws. Screws from another device
may have a different thread, and will damage this drive.
2
3