INSTALLING THE REFRIGERATOR (cont.)
REMOVE THE REFRIGERATOR DOORS (cont)
Note: for proper installation later, please follow the next step
carefully.
e o e the tape and keeping the door as
F
straight as possible open the door to
straight up to re o e it
Li t up
o
center hinge
REMOVE OPPOSITE DOOR
Follow the sa e procedure on the opposite door
There are no wires or water lines on the opposite side
REMOVE CENTER HINGE (if necessary)
e o e the
screws securing the center hinge to the
cabinet
se T
dri er to re o e outboard screw
e o e
center screw
Loosen uter
screws
Installation Instructions
then li t
pen Door to
REINSTALLING THE REFRIGERATOR DOORS
Reverse steps 1 through 4 to reinstall refrigerator, follow
details below for critical alignments.
A Reinstall center hinge first and torque the screws to 65
in-lbs. With the L door at
the case lower the re rigerator door onto the center
hinge nsure that the door and hinge align correctly
otate doors closed and ake sure o eable center
sealing portion o the door aligns with the striker If the
door will not self-close after reinstalling, remove door, turn
door upside down, check alignment mark and arrow;
(there is an alignment mark on the door closure
mechanism It corresponds to an alignment arrow on
the plastic ring. Rotate door closure mechanism to align
mark and arrow, reinstall door).
Align lats with tab
If door cannot be installed at 90° follow steps below:
nstall door at
to case ront
space li its opening door to less than
a e o e door care ully turn door upside down
b Check align ent o door closure
underside o door The lats on the sha t should correspond
to align ent tab on plastic ring or
c
sha t is not aligned to tab
rotate door closure
echanis
or right door and clockwise or le t door Then align
lat with tab
ark
d nstall the door at
Securely tape the door shut with masking tape or have a
second person support the door. Reinstall the top hinge
and torque the screws to 65 in-lbs.
C e sure to reinstall the ground wire and strain relie to the
top hinge
D einstall hinge co er NOTE: nsure wires are not
pinched or under screw bosses be ore tightening
screws
to the ront o
nderside F
Fresh Food Door
then
echanis
sha t on
ark on botto
end cap
ark using
Allen wrench
sha t counterclockwise