Loose Parts List - Ryobi P553 Manuel D'utilisation

The following items are included with your compound miter saw:
 Dust Bag
 Work Clamp
DUST BAG
WARNING:
The use of attachments or accessories not listed might be hazardous and could cause serious personal injury.
UNPACKING
This product requires assembly.
 Carefully lift miter saw base from the carton by the "D"
handle and the saw base, and place it on a level work
surface.
WARNING:
Do not use this product if any parts on the Loose Parts List
are already assembled to your product when you unpack
it. Parts on this list are not assembled to the product by
the manufacturer and require customer installation. Use
of a product that may have been improperly assembled
could result in serious personal injury.

LOOSE PARTS LIST

 Blade Wrench
 Rear Bracket
REAR
BRACKET
WASHER
BLADE
WRENCH
ASSEMBLY
 This saw has been shipped with the saw arm secured in
The saw arm is spring loaded. Hold the handle down
to prevent from snapping up when cutting the tie-wrap.
Failure to do so could result in possible serious injury.
 Lift the saw arm by the "D" handle. Hand pressure should
 Inspect the tool carefully to make sure no breakage or
 Do not discard the packing material until you have carefully
11 – English
 Operator's Manual (not shown)
BEVEL LOCK
KNOB
MITER
LOCK KNOB
the down position. To release the saw arm, push down
on the top of the saw arm, cut the tie-wrap, and pull out
the lock pin.
WARNING:
remain on the saw arm to prevent sudden rise upon
release of the tie wrap.
damage occurred during shipping.
inspected and satisfactorily operated the tool.
WORK
CLAMP
Fig. 5