Festo DNCI−32 Notice D'utilisation page 28

DNCI−...
If the DNCI−... is used with electronic control:
Please note
Special commissioning regulations apply to the electronic control of the
DNCI−...:
S Complete commissioning as described in the manuals for the controllers
type SPC... .
Start a test run (at the lowest permitted pressure).
S
Check to see if the settings on the DNCI−... or on the controller need to be
S
modified:
Reference stop
Speed
Switching points
Movement sequence
Conclude the test run.
S
7 Operation
Warning
Uncontrolled moving parts can cause
injury to people in the vicinity of the
DNCI−... .
S Make sure that nobody can place his/
her hand in the positioning range of the
work load (e.g. by means of a protective
screen).
If the DNCI−... is protected correctly, it
should not be possible to gain access to
it until it has come to a complete stand.
S Make sure that no objects project into
the positioning range of the work load.
28
Fig. 16
Festo DNCI−... 0610a English