Festo DNCI−32 Notice D'utilisation page 25

DNCI−...
Fitting pneumatic components
Remove the adhesive labels on the
S
compressed air connections.
Connect the tubing of the DNCI−... to
S
the compressed air connections.
DNCI−...
Connector
thread
Fig. 11
If the DNCI−... is used as a measuring cylinder:
Screw the one−way flow control valves of type GRLZ−... or GRLA−... directly
S
into the relevant compressed air connections.
One−way flow control valves enable the speed to be set.
If the DNCI−... is used with electronic control:
Please note
S Take into account the mounting specifi
cations and instructions especially for
the DNCI−... in the manual for the con
trollers type SPC... .
Use the proportional directional control
S
valve type MPYE−... for controlling the
DNCI−... .
The proportional directional control valve
in conjunction with the controller elec
tronics creates the desired movement by
means of the difference in pressure on the
two piston surfaces.
Festo DNCI−... 0610a English
32 40 50
G1/8
G1/4 G1/4
63
G3/8
Fig. 10
Fig. 12
25