Festo DNCI−32 Notice D'utilisation page 27

DNCI−...
6 Commissioning
Warning
Uncontrolled moving parts can cause injury
to people in the vicinity of the DNCI−... .
S Make sure that nobody can place his/her
hand in the positioning range of the
work load (e.g. by means of a protective
screen). If the DNCI−... is protected cor
rectly, it should not be possible to gain
access to it until it has come to a com
plete stand.
S Make sure that no objects project into
the positioning range of the work load.
If the DNCI−... is used as a measuring cylinder:
Observe the commissioning instructions for the measuring signal amplifier
S
used.
1. Push the piston rod at first into a mechanical end position.
2. Screw the one−way flow control valves into both compressed air connections
at first completely (as supplied from the factory),
then open them up again one turn.
The DNCI−... will then move slowly over the complete positioning path.
3. Slowly pressurize the compressed air connection of the mechanical end
position.
4. Start a test run.
5. Unscrew the one−way flow control valves until the desired speed is reached.
6. Conclude the test run.
Festo DNCI−... 0610a English
Fig. 15
27