KREA Swiss hotCHOC Mode D'emploi page 6

CLEANING
IMPORTANT: Always remove the electrics and heating unit before washing the
gun. These parts should never be exposed to liquids.
Always clean immediately after use. For external cleaning, simply wipe down the
outside of the sprayer with an approved food grade detergent. For internal cleaning,
we recommend to spray half a container of very hot water through and then clean
the individual parts using a suitable food safe mild detergent. Careful use of a soft
pipe cleaning brush is also recommended but care should be taken not to damage the
cylinder by using abrasive or sharp tools. If available, blowing air through the nozzle
and suction tube can ease the cleaning process. Rinse thoroughly thereafter with hot
fresh water.
The sprayer is designed with quality components. If you experience any issue, we
recommend first following the trouble shooting document and films on our
website: www.KreaSwiss.com/professional-food-sprayer-guns. In most cases
a part has been forgotten or the product needs a thorough cleaning. If your issue
persists, please contact your reseller for additional support. Please always include the
article number (Page 2) in any correspondence.
DISMANTLING AND ASSEMBLING (see page 2)
• Unscrew the round jet nozzle (9) and slide off the nozzle heating unit (14). Then
unscrew the bent nozzle extension (8) from the pump housing (5).
• Remove the 3 piece "atomiser unit" (7) from inside the chamber. The metal
adapter (6) should never be removed. Place all parts in a small dish and clean
them following the cleaning steps outlined earlier. The suction tube (10),
container (11), container insulation sleeve (12) and nozzle insulation sleeve (13)
can be washed in the sink.
• Remove the service screw (2) and take off the pump housing (5). Put the
piston (3), piston spring (4) and hood (1) to one side and wipe them down as
outlined above.
• To assemble the gun, do so in reverse order. The piston should move freely in the
pump housing. Ensure the service screw, bent nozzle extension and round jet
nozzle pieces are all screwed on tightly.
6