Pit Boss LEXINGTON Instructions Et Recettes page 10

9. INSTALLING THE COOKING GRIDS
Parts Required:
2 x Cooking Grids (#2)
1 x Upper Cooking Rack (#1)
• Place the cooking grids, side-by-side, on the grid ledge inside the main grill.
10. PLACING THE GREASE BUCKET
Parts Required:
1 x Grease Bucket (#13)
Installation:
• Place the grease bucket on the spout hook on the end of the main
barrel. Ensure it is level to avoid grease spills.
• The unit is now completely assembled.
NOTE: To maintain the searing and grilling performance of your
cooking grids, regular care and maintenance Is required.
11. CONNECTING TO A POWER SOURCE
NOTE: Before plugging your Pit Boss into any electrical outlet, ensure
the Temperature Control Dial is in the SMOKE position.
STANDARD OUTLET
•
This appliance requires 110 volt, 60hz, 250w, 5 amp service. It must be a
3-prong grounded plug. Ensure grounded end is not broken off before
use. The control uses a 5 amp, 120 volt, fast-blow fuse to protect the
board from the igniter.
• GFCI OUTLETS
This appliance will work on most GFCI outlets, with a recommended
size of 15 amp service. If your GFCI outlet is highly sensitive to power
surges, it will likely trip during the start-up phase of operation. During
the start-up phase, the igniter draws 200-700 watts of electricity,
which can be too much power for a GFCI outlet to handle. Each time it
trips, it increases in sensitivity. If the GFCI keeps tripping, replace the
outlet or change to a non-GFCI outlet.
ON THE ROAD
•
Disconnect the igniter from the main wiring harness. Use the manual
start-up procedure. A Pit Boss unit can operate using a 12 volt, 100 watt
inverter plugged into your automobile outlet. To use the automatic
igniter, it is recommended to use a minimum of a 1000 watt inverter.
IMPORTANT: Disconnect unit from power source when not in use.
10
9
10
11
FAST-BLOW FUSE,
5 AMP