Nitty-Gritty TIG.CLINOX EVO Manuel D'utilisation page 35

7.6. M
ARKING OPERATIONS
1. Lean the marking screen (38) on workpiece.
2. Put some drops of electrolyte solution (36/37) on the marking felt (34) (Picture K4).
Pay attention: it is not necessary to soak the felt (34) every time if making a number of marks in sequence (max 15).
3. Machine ON: power switch (7) on "I" position (ON).
4. Pass several time the marking felt (34) soaked of electrolytic solution (36/37) on the marking screen (38) without exit to the
edge on the screen, otherwise stainless steel surface is damaged (Picture K5).
7.7. A
FTER MARKING
1. Recover the handgrip (31) on its support (22).
2. Put the power switch (7) on "O" position (OFF).
3. Remove the ground clamp (19) from the marked workpiece.
4. Unplug the machine power cable (6).
After marking, never put handgrip (31) on the stainless steel with power switch (7) ON, otherwise marking
continue and workpiece will be damaged.
Remove the marking screen (38); spray the INOX FIT solution (40) on the workpiece and clean the surface
using a sponge or blotting paper to bring out the final result (Picture K6).
Wash the marking screen (38) with water to avoid the formation of any deposit.
8. MAINTENANCE
Pay attention: before any maintenance it is necessary to disconnect the machine from the mains.
8.1. O
RDINARY MAINTENANCE
Before every work shift:

Check the condition of the machine's components and replace them if necessary; use only original parts.

Check the condition of the electrical equipment and value its reliability during operation.
At the end of work shift clean the machine:

Remove the pad/brush (28/34/41/44/30) from the insert (16/27/33/43) of the torch to prevent encrustations of the
electrolyte on the tip due to evaporation and corrosion on the electrode. Whenever the pad/brush (28/34/41/44/30) is worn
or burnt, replace it with a new one before restart working. If the pad/brush (28/34/41/44/30) does not require replacement,
rinse it out with water.

Once it has cooled down, clean the insert (16/27/33/43) and tip of the torch to prevent encrustations.
Pay attention: N
ITTY
8.2. S
PECIAL MAINTENANCE
Extra-duty maintenance is generally effected by qualified technical of N
Pay attention: the N
ITTY
authorized people.
-G is not liable for the consequences if other products are used.
RITTY
-G guarantee will fall if the product is dismounted repaired or in any case handled by not
RITTY
- EN -
VERY IMPORTANT
-G or authorized centers.
ITTY RITTY
- 35 -