Continuous Operation; Replacing The Power Cable; Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL TC-DW 225 Mode D'emploi D'origine

Note:
Connect your tool to an extraction unit or vacuum
cleaner. This will provide excellent extraction of
chips and dust.
Caution!
For health safety reasons it is imperative that you
use a dust extractor.
5.4 Fastening the grinding/sanding paper
(Fig. 5)
The Velcro fastener enables easy changing of
the abrasive paper. Make sure that the vacuum
extraction holes on the abrasive paper and the
sanding disk are aligned.
6. Operation
6.1 On/Off switch (Fig. 6/7)
Switching on:
Press the On/Off switch (1).

Continuous operation:

Lock the On/Off switch (1) in place by pressing
the locking button (11).
Switching off :
Press the On/Off switch (1) briefl y and let go.
6.2 Speed controller (Fig. 7/Item 2)
You can select the speed by turning the speed
controller (2).
Plus direction: Higher speed
Minus direction: Lower speed
6.3 Working with the drywall power sander
•
Place the whole surface area of the sanding
disk on the material.
•
Switch on the machine and move it with
gentle pressure over the „workpiece", making
circular or transverse and linear movements.
•
Use a coarse grit for coarse sanding and a
finer grit for finish sanding. You can find the
best grit size for the job by carrying out san-
ding tests.
Caution!
The dusts which are formed while the equipment
is being used may be a health hazard:
•
Always wear safety goggles and a dust mask
during sanding work.
Anl_TC_DW_225_SPK7.indb 16 Anl_TC_DW_225_SPK7.indb 16
GB
•
All persons who work with the equipment or
enter the workplace must wear a protective
dust mask.
•
Eating, drinking and smoking are prohibited
at the workplace.
•
Paints containing lead are not allowed to be
used!
6.4 Swiveling sanding disk (Fig. 1)
The sanding disk can be swiveled in two axes,
enabling comfortable sanding even overhead and
in tight spaces.

7. Replacing the power cable

Danger!
If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
after-sales service or similarly trained personnel
to avoid danger.
8. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the mains power plug before star-
ting any cleaning work.
8.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
8.2 Carbon brushes
In case of excessive sparking, have the carbon
brushes checked only by a qualifi ed electrician.
Danger! The carbon brushes should not be rep
laced by anyone but a qualifi ed electrician.
- 16 -
05.10.2016 14:06:19 05.10.2016 14:06:19