Panasonic TY-ST85P12 Manuel D'installation page 8

2. Join the stand hooks to the 4 notches
on the display mounting fixture and
let them drop in until they stop.
3. Starting with the upper left side of the left and
right display mounting fixtures  , attach the 2
screws for securing unit  .
•
The screws should be securely tightened to the
torque given below.
(1.2~1.5 N•m)
Note
•
Do not over-tighten the screws for securing unit  ,
as this could cause the fixtures to deform.
4. Remove the suspension device.
Remove the eye bolt and insert the eye bolt cap
(provided with the plasma display).
※ Carefully store the removed eye bolt.
5. Installing the grounding plate
Notes
•
The stamped marks (L and R) on the grounding plates
are as seen from the rear of the display.
•
Attach the grounding plates the same way for both
supports (left and right).
1) Loosely insert the grounding plate screws  (2
each on the left and on the right) to the holes on
the upper end of display mounting fixtures  .
Stand hooks
Front
Front
Display mounting fixtures 
Notches
Screw for securing unit 
Grounding plate screws 
Rear
Rear
19