HOLZMANN MASCHINEN TSM 250 Mode D'emploi page 25

13 MAINTENANCE
Don't clean or do maintenance on the machine while it is still connected to
the power supply:
Damages to machine and injuries might occur due to unintended switching
on of the machine!
Therefore: Switch the machine off and disconnect it from the power supply
be-fore any maintenance works or cleaning is carried out
The machine does not require extensive maintenance. If malfunctions and defects occur, let it be
serviced by trained persons only.
Before first operation as well as later on every 100 operation hours you should lubricate all con-
necting parts (if required, remove beforehand with a brush all swarfs and dust).
Check regularly the condition of the security stickers. Replace them if required.
Check regularly the condition of the saw band and the saw band guide.
The good condition and perfect adjustment of the guiding rollers is essential for a smooth band
guidance and a clean cut.
Store the machine in a closed, dry location.
Clean your machine regularly after every usage – it prolongs the machines lifespan and is a
pre-requisite for a safe working environment.
Repair jobs shall be performed by respectively trained professionals only!
13.1 Maintenance plan
After each workshift: Remove chips and sanding dust from the device
After 10 hours of operation: Check all screw connections and tighten if necessary.
13.2 Changing grinding disc
If the grinding disc (e) is worn, pull it off the
grindingplate.
Place the new disc with enough suitable adhesive on the
centre and push it on to the grinding plate.
Remove the grinding disc if it does not run circularly.
Readjust it.
13.3 Storage
 Store the machine in a dry and for children not reachable place.
HOLZMANN MASCHINEN GmbH
N O T I C E
www.holzmann-maschinen.at
A T T E N T I O N
MAINTENANCE
25
TSM 250