HOLZMANN MASCHINEN TSM 250 Mode D'emploi page 23

12 OPERATION
Check right after receiving the machine, whether all parts according to the parts list are complete
and without damage. Each visible defect and in particular wrong amounts and transport damages
must be clearly noted on the delivery documents, otherwise the goods shall be considered as
taken over and fully accepted under the sole responsibility of the customer.
12.1 Operation instructions
Device to be operated in a perfect state only. Inspect the device visually every time it is to be
used. Check in particular the safety equipment, electrical controls, electric cables and screwed
connection for damage and if tightened properly. Replace any damaged parts before operating
the device.
Perform all machine settings with the machine being
Please observe the following operating instructions so that their work
can be performed safely and has the expected success.
Check before starting work:



The sanding:




HOLZMANN MASCHINEN GmbH
W A R N I N G
disconnected from the power supply!
All cables and plugs
Table and safety fence on tight fit
The free and centered run of sanding belt and disc
Always use the proper, located in perfect condition abrasives. (Change
wear of abrasives immediately!) With abrasive in good condition you
obtain a good grinding result.
Do not exert too much pressure to the sanding abrasive
Maximum distance table-sanding disc: 2mm!
The machine has no clamp opportunity, so it is important, as the whole
area hang up the work piece on the worktable and maintain a firm grip!
www.holzmann-maschinen.at
A T T E N T I O N
N O T I C E
OPERATION
23
TSM 250