Télécharger Imprimer la page

AEG BSE778380B Notice D'utilisation page 132

Masquer les pouces Voir aussi pour BSE778380B:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 164
12.3 Pyrolytic Cleaning
Use it to clean the appliance and burn off the
residues.
WARNING!
There is a risk of burns.
CAUTION!
If there are other appliances installed in
the same cabinet, do not use them at the
same time as this function. It can cause
damage to the oven.
Do not start the function if you did not fully
close the oven door.
1. Turn off the appliance and wait until it is
cold.
2. Remove all accessories.
3. Clean the oven floor and the inner door
glass with warm water, a soft cloth and a
mild detergent.
4. Turn on the appliance.
5. Press
/ Cleaning.
6. Select the cleaning mode.
Option
Pyrolytic cleaning, quick
Pyrolytic cleaning, normal
Pyrolytic cleaning, intense
When the cleaning starts, the oven door is
locked and the lamp is off. The cooling fan
works at a higher speed.
- press to stop the cleaning before it is
completed.
Water hardness
Level
dH
1
0 - 7
2
8 - 14
132
ENGLISH
Duration
1 h
1 h 30 min
2 h 30 min
Test strip
Calcium deposit
(mg/l)
0 - 50
51 - 100
Do not use the appliance until the door lock
symbol disappears from the display.
7. When the cleaning ends, turn off the
appliance and wait until it is cold.
8. Clean the oven interior with a soft cloth.
Remove the residue from the bottom of
the oven.
12.4 Cleaning the water tank
1. Turn off the appliance.
2. Place a deep pan below the steam inlet.
3. Pour water into the water drawer: 850 ml.
Add citric acid: 5 teaspoons. Wait for 60
min.
4. Turn on the appliance and set the
function: Humidity Low. Set the
temperature to 230 °C.
5. Turn off the appliance after 25 min and
wait until it is cold.
6. Turn on the appliance and set the
function: Humidity Low. Set the
temperature between 130 and 230 °C.
7. Turn off the appliance after 10 min and
wait until it is cold.
8. Empty the water tank. Refer to Daily use,
"Emptying water tank" chapter.
9. Rinse the water tank and clean the
remaining limestone residue with a soft
cloth.
10. Clean the drain pipe with warm water and
a mild detergent.
The table below shows water hardness range
(dH) with the corresponding level of calcium
deposit and the quality of water. When water
hardness exceeds level 4, fill the water
drawer with bottled water.
Water classi‐
fication
soft
moderately hard
Clean the wa‐
ter tank every
75 cycles - 2.5
months
50 cycles - 2
months

Publicité

loading

Ce manuel est également adapté pour:

Bse778380mBsk778380m