SciCan Aquastat W 10000 Guide D'utilisation Et D'entretien page 9

Operating Instructions
12. Place the water bottle on the base of the distiller chassis. The base of
the distiller chassis has raised edges to assist in positioning the water
bottle properly.
NOTE: Do not remove the water bottle while the distiller is running.
13. At the end of the distillation cycle (about 4 to 4
will shut off automatically and the "start" light will go out. The fan
will continue to operate for several minutes. Let the distiller cool
completely before removing the boiling chamber from the chassis.
14. Unplug the cord from wall outlet when not in use.
NOTE: Approximately 8 ounces (240 ml) of water will remain in the boiling
chamber at the end of the distillation cycle. This feature reduces scale deposits
in the boiling chamber.
CAUTION: To prevent personal injury, burn, or scald injury, do not remove the
boiling chamber while the start button is illuminated or at any time when the
boiling chamber is hot. Always unplug the distiller from the wall outlet and allow
the boiling chamber to cool completely before removing it from the distiller.
NOTE: The water bottle has been designed to hold one gallon (4 liters) of
water. Therefore, the water bottle will not fill completely.
Once the distillation cycle is complete, secure the cap onto the water bottle to
avoid spilling. The cap must be opened slightly before dispensing water.
Use and Care Guide
(Continued)
1 ⁄ 2 hours), the distiller
7