SciCan Aquastat W 10000 Guide D'utilisation Et D'entretien page 8

Operating Instructions
8. Slide the boiling chamber into the distiller
chassis and press firmly to insure that it
is properly placed. It is important that the
boiling chamber be pressed firmly into the
distiller chassis. It is recommended that
you place one hand on the back of the
distiller chassis and push the boiling
chamber into the chassis with the other
hand. To ensure
that a tight electrical connection is made,
press on the base of the boiling chamber
near the start button also.
CAUTION: To prevent personal injury or property
damage, the boiling chamber must be fully
engaged prior to start-up.
9. Press the "start" button at the base of the
boiling chamber.
NOTE: The button will glow when the boiling
chamber is heating, however, the light will go out
and the boiling chamber will stop heating if electrical
power to the boiling chamber is interrupted or
stopped. If this occurs, press the start button
again to restart the distillation cycle.
10. The cooling fan will not start immediately.
A delayed fan startup feature has been included
in your distiller. The fan will start once the
boiling chamber has reached a pre-determined
temperature, approximately 30-40 minutes after
starting the cycle.
NOTE: Do not install the cap onto the water bottle.
The bottle must be left uncapped to allow water to enter
it from the distiller.
11. Make sure that the dispensing valve is securely
tightened onto the water bottle.
Use and Care Guide
(Continued)
Baffle Gasket O-Ring
Flat edge
Baffle
of baffle
Securing
Spout
Nut
Dispensing Valve
6