Sanitize The Water Bottle; Preparing Your Aquastat; Clean The Water Bottle - SciCan Aquastat W 10000 Guide D'utilisation Et D'entretien

Preparing Your Aquastat

Cap
Dispensing
Valve
Water Bottle
To Clean the Water Bottle
First, make sure the dispensing valve is installed and tightened onto the water
bottle. Then fill the water bottle about
of dish washing detergent to the water. Seal the bottle's top opening with the
cap supplied. Shake the bottle vigorously and then drain. Rinse the bottle
thoroughly to remove all of the detergent.
NOTE: Do not allow the soap / water mixture to remain in the water bottle for
long periods of time. Do not use the water bottle to store liquids other than
distilled water. Liquids other than distilled water may contaminate the water
bottle.
To Sanitize the Water Bottle
Add 5 ounces (150 ml) of 3% hydrogen peroxide solution (H 2 O 2 ) to the water
bottle. Fill the bottle with hot (160˚F, 71˚C) distilled or tap water. Cap the water
bottle. Shake the water bottle vigorously. Let stand for twenty minutes then
drain thoroughly. Rinse with room temperature distilled or tap water, then drain.
Water bottle may be used immediately or allowed to air dry. Your distiller is
now ready for use.
NOTE: Be sure to place the distiller in a location that provides adequate
ventilation during operation, with at least 4 inches (10 cm) of clearance to the
sides and back and 3 inches (8 cm) to the top of the unit. Do not operate the
distiller in an enclosed area such as a cupboard or cabinet. The distiller must
be operated only in areas with ambient air temperature of 40˚F-110˚F (5˚C-
45˚C).
Use and Care Guide
TM
Cap
Baffle
Securing
Boiling Chamber
full with water. Add one or two drops
3 ⁄ 4
Nut
Distiller Chassis
Cooling
Vents
Cord
4