Operating Instructions - SciCan Aquastat W 10000 Guide D'utilisation Et D'entretien

Operating Instructions

1. Place the distiller on a dry, level surface in a well ventilated area.
Plug the cord into a properly grounded rated voltage AC electrical
outlet ONLY.
2. Remove the boiling chamber from the distiller by grasping its handle and
pulling it straight out of the distiller chassis. Do not lift up when pulling the
boiling chamber out of the chassis.
CAUTION: To prevent personal injury, burn, or scald injury,
do not remove the boiling chamber until it has cooled completely.
3. Remove the boiling chamber cap by turning it counterclockwise.
Note the four tabs at the base of the boiling chamber fill opening.
4. Fill the boiling chamber with cold tap water to the bottom of the four tabs
which equals 1 gallon (4 liters). Do not overfill the boiling chamber.
Overfilling the boiling chamber may result in leakage, electrical
failure, electrical hazard, or damage to the distiller.
5. Replace the boiling chamber cap by turning it clockwise.
6. Make sure the baffle is in place and its securing nut is tightened.
To do this, insert the long end of the baffle, flat side down into the spout
and secure with the nut. The hole on the flat side of the baffle should be
facing down. It is important that you tighten the securing nut, with baffle
properly in place, onto the boiling chamber before each use. Failure to
properly secure the baffle and nut may result in leakage or early shut off of
the distiller.
7. Wipe off any water on the outside and bottom of the boiling chamber and
around the electrical connection.
Use and Care Guide
Boiling
Chamber
Cap
Start
Button
Tabs
Water
Fill
Level
5