Aim TTi EL302P Manuel D'instructions page 2

Introduction
Specification
Safety
Installation
Connections
Operation
Remote Operation
Remote Commands
Maintenance
Instructions en Francais
Bedienungsanleitung auf Deutsch
Istruzioni in Italiano
Instrucciones en Español
The EL302P is a digitally controlled version of the standard EL302 linear power supply with an
isolated RS-232 interface.
It offers a low-cost solution for a basic programmable PSU, and will be sufficient for many
applications where the sophistication and complexity of GPIB is not needed.
A simple command set allows remote control of voltage, current and output enable together with
read-back of metering values and operational status.
Local control is via three rotary encoders providing rapid and accurate setting of voltage and
current during bench use.
Excellent line and load regulation is matched by very low noise and good transient response.
Improved power efficiency ensures that the units require no fan cooling.
The EL series has been designed to meet the stringent requirements of relevant IEC standards
for safety and EMC. All outputs are intrinsically short circuit proof and are protected against
external voltages and reverse currents.
Table of Contents
Introduction
1
2
4
5
6
6
8
10
12
13
21
29
37
1