Publicité
Les langues disponibles
Les langues disponibles
Problem
Water flows inside the refrigerator.
Water flows on the floor.
The temperature in the appliance is
too low/too high.
If the advice does not lead to the desired
result, contact the nearest Authorised
Service Centre.
Replacing the lamp
Caution! Disconnect the plug from the
mains socket.
1. Pull the left side of the lamp cover with your fingers
to unlock it. Remove the cover by pulling it towards
yourself.
Possible cause
The water outlet is clogged.
Food products prevent that water
flows into the water collector.
The melting water outlet is not
connected to the evaporative tray
above the compressor.
The temperature regulator is not
set correctly.
The door is not closed correctly.
The food products' temperature is
too high.
Many food products are stored at
the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened often.
There is no cold air circulation in
the appliance.
1
2
1
Clean the water outlet.
Make sure that food products do not
touch the rear plate.
Attach the melting water outlet to the
evaporative tray.
Set a higher/lower temperature.
Refer to "Closing the door".
Let the food products temperature de-
crease to room temperature before
storage.
Store less food products at the same
time.
Defrost the appliance.
Open the door only if necessary.
Make sure that there is cold air circula-
tion in the appliance.
2. Replace the lamp with one of the same power and
shape, specifically designed for household
appliances. The maximum power is shown on the
light bulb cover.
3. Install the lamp cover.
4. Connect the plug to the mains socket.
5. Open the door.
Make sure that the light switches on.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to assembly
instructions.
3. If necessary, replace the defective door gaskets.
Contact the Authorised Service Centre.
Solution
19
Publicité
