GE UVC9480 Manuel Du Propriétaire Et Instructions D'installation page 19

Installation - UVC 9420 and 9480
STEP 5 INSTALL BLOWER MOTOR ASSEMBLY - UVC-9420 AND 9480
METHOD 1
1. Lift the motor assembly on the insert canopy.
2. Insert the blower motor assembly tabs in the hood
slots and slide it, such that the motor assembly
slides from right to left into the 4 slots.
Slots on Hood
49-2000930 Rev. 2
3. Tighten the 4 screws (removed earlier) - see
4. Reconnect the 4 cables of the motor to the ones
Mounting Tabs
5. Mount the metal lid and tighten the 3 screws to
Remove Motor Assembly from Hood Canopy
section. Make sure the blower motor is secured
firmly to the hood canopy.
Screws
on the hood side and insert them into the protected
area under the control panel.
Connectors on
Hood Side
Connectors on
secure the lid on the hood body.
Metal Lid
Motor Side
Screws
19