GE UVC9480 Manuel Du Propriétaire Et Instructions D'installation page 18

STEP 3 INSTALL HOOD CANOPY
TO THE CABINET
1. Install the right and left side panels to the hood
canopy using the 4 screws (B) provided.
Hood Canopy
Side Panel (1 per side)
2. Tuck the house wiring out
of the way.
3. Push the hood canopy
straight up through the
cutout opening until the
temporary locking clips
engage. The locking
clips are designed to hold the insert sleeve in
place until it is secured with screws.
NOTE: The locking clips are not designed to support
all of the weight of the insert sleeve. Do not leave
the insert sleeve unattended until screws have been
installed.
4. Fasten the 8 screws (L), 4 on each side, toward
the left and right sides to the side studs of the
cabinet structure. It is recommended to start
with one corner and fasten screws diagonally to
ensure unit flushness with cabinet.
18
Installation - UVC 9480
Clip
2x4 Stud
STEP 4 INSTALL DAMPER
1. Seal the duct to the damper with duct tape (DO
NOT USE SCREWS).
2. Install the damper into the bottom of the exhaust
fan opening using 2 screws provided (D).
a. Check to make sure the damper opens freely.
b. Tighten the 2 screws (D).
Screws
49-2000930 Rev. 2