Publicité
Les langues disponibles
Les langues disponibles
BM 2609140642 05-09:BM 2609140642 05-09 5/19/09 10:16 AM Page 11
FORWARD/REVERSING
LEVER & TRIGGER LOCK
After tool use, lock trigger in
C UTION
"OFF" position to help prevent
accidental starts and accidental discharge.
Your tool is equipped with a forward/
reversing lever and trigger lock located above
the trigger (Fig. 4). This lever was designed
for changing rotation of the bit, and for locking
the trigger in an "OFF" position.
For forward rotation, (with chuck pointed
away from you) move the lever to the far left.
For reverse rotation move the lever to the far
right. To activate trigger lock move lever to
the center off position.
Do not change direction of
W RNING
rotation until the tool
comes to a complete stop. Shifting during
rotation of the chuck can cause damage to
the tool.
BUILT IN WORK LIGHT
Your tool is also equipped with a light that turns
on automatically when the switch is activated,
for better visibility when driving (Fig. 1).
BIT STORAGE AREA
(Models 25614 & 25618 only)
Your tool is equipped with a bit and storage
area that is conveniently located in the handle
base where it is always handy and unlikely to
get lost or misplaced (Fig. 5).
BELT CLIP (Optional Accessory)
When the tool is attached to
W RNING
the belt, position yourself to
avoid entanglement with surrounding objects.
Unexpected entanglement could cause the tool
to fall resulting in injury to the operator or
bystanders.
The optional belt clip accessory will allow you to
conveniently attach your tool to your belt. This
feature will allow you to have both hands free
when climbing a ladder or moving to another
work area.
Set Forward/Reversing lever to the center (off
position). Slide charged battery pack into the
housing until the battery pack locks into
position (Fig. 6).
INSERTING AND RELEASING BATTERy PACK
FORW RD/REVERSING
LEVER & TRIGGER LOCK
The belt clip can be attached to either side of
the tool by securing it with a mounting screw.
Always make sure you securely tighten the
mounting screw before use (Fig.5).
To use clip, turn tool upside down and attach
to your belt.
Your tool is equipped with a secondary locking
latch to prevent the battery pack from
completely falling out of the handle, should it
become loose due to vibration.
-11-
FIG. 4
FIG. 5
BIT ND BIT
STOR GE
RE
BELT CLIP
(Optional ccessory)
Publicité
