cecotec CONGA 2690 Manuel D'instructions page 43

All manuals and user guides at all-guides.com
The robot did not carry out the scheduled
cleaning task.
The robot does not return to the charging
base after spot cleaning or after changing
starting position.
The robot does not resume cleaning.
The robot is always offline.
Connection between the mobile phone and
the robot failed.
Main brush error.
Left wheel error.
Right wheel error.
Side brush error.
Check if the robot is in Night mode and switch
mode. The robot does not carry out scheduled
cleaning cycles under this mode.
Make sure the robot is connected to the
network, it will not be able to carry out
scheduled cleaning tasks without being
connected.
The robot will map and calculate a new route
after operating under spot cleaning or after
having changed its starting position.
If the charging base is very far away from
the robot, it will not be able to charge back
automatically. Put the robot back on the
charging base manually.
Make sure the robot is not in Sleep mode, it
will not resume cleaning under this mode.
It won't resume cleaning when it is placed
manually on the charging base.
Make sure the robot is successfully connected
to the network and always in the range
covered by the Wi-Fi signal.
Make sure the robot and the charging base
are in an area with good Wi-Fi signal, reset
the router and try connecting them again.
Make there are no foreign objects entangled
in the main brush. If there are, clean the brush.
Make there are no foreign objects entangled
or blocking the left wheel. If there are, clean
the wheel.
Make there are no foreign objects entangled
or blocking the right wheel. If there are, clean
the wheel.
Make there are no foreign objects entangled
in the side brushes. If there are, clean them.
ENGLISH
43