cecotec CONGA 2690 Manuel D'instructions page 34

All manuals and user guides at all-guides.com
ENGLISH
as it features memory and gyroscopic navigation supported by its camera.
Moreover, it changes direction when it finds obstacles throughout its route and it returns to
the charging base in a smart and direct way once the cleaning is over. It includes Total Surface
function, through which the robot cleans the whole surface and, if necessary, returns to the
charging base to recharge its battery and finish cleaning.
Back home mode
This mode can be selected at any point of any cleaning cycle. Once it is activated, the robot will
automatically return to the charging base.
Warning: Make sure not to charge the robot with the Wet & dry tank installed when it contains
water.
Remote control
Fig.23.
Schedule
Power levels (Turbo/Normal/Eco)
Back home
Time
Manual control
On/Pause
Edge mode
Schedule
Warning: The robot cannot be scheduled from more than one device at a time. Make sure to
schedule it either from the mobile phone App or from the remote control.
The first time the robot is operated, it will map the whole house. The map will be saved to the
robot's memory once it has finished cleaning.
Note: Make sure the light indicator is lit up in blue before starting cleaning, indicating it is
activated. If not, press any button on the remote control to wake it up.
Remote control binding
If the robot does not respond to the remote control, follow the below steps:
Press the edge mode button on the remote control for 5 seconds for the remote control to
enter pairing mode. The screen will display 8888.
The remote receiver will be activated in 5 seconds and will enter pairing mode. The
remote control's signal is received and the remote control returns to normal status. The
display will show pairing is completed.
If the pairing process is unsuccessful, the remote control will display 8888 and will exit the
pairing mode after 30 seconds.
Time settings and scheduling
34