cecotec CONGA 2690 Manuel D'instructions page 32

All manuals and user guides at all-guides.com
ENGLISH
Warnings:
Remove all objects around the robot such as clothing, papers, cables, curtains or other fragile
objects.
Fig. 12.
If the area to be cleaned has a balcony or stairs, a physical barrier must be placed in order to
prevent product damage and ensure safe operation.
Fig. 13.
4. INSTALLATION
Robot and charging base installation
Connect the charging base to a power supply and store the remaining cable. It is important to
store the remaining cable at the bottom of the charging base to avoid it from being dragged
and disconnected.
Fig. 14.
Place the charging base against the wall, leaving the safety distance indicated in the below
picture.
Fig. 15.
Note: Ensure a space of at least 1 m on both the left and right side of the charging base, and a
space of at least 2 m in front of it.
Warning: Do not expose the charging base to direct sun light.
Long press the power button for 3 seconds; when the light indicator turns on, place the robot
on the charging base.
Fig. 16.
Steady blue light: ON/operating
Orange light oscillates: charging
Red light blinks: Error
Note:
Take the robot to the charging base if the battery is low. The robot might not turn on if the
battery is very low.
The robot will automatically turn on when placed on the charging base.
The robot cannot be turned off during charging.
Wet&Dry tank installation
Note: It is not suggested to use the scrubbing function for the first-time use.
Open the tank's rubber lid, fill the tank with water and close it again.
Fig. 17.
32