KitchenAid 720-0826 (LP) Instructions D'installation Et Guide D'utilisation Et D'entretien page 21

5. Re-Insert the searing main burner and lock all removed
screws.
Change Grill Rotisserie Burner Orifices
1. Using a Phillips screwdriver, unscrew the 2 screws and
remove the rotisserie burner heat shield.
2. Using a Phillips screwdriver, remove the
back of grill from inside the grill
the rotisserie burner).
6 screws at the
(3 screws on each side of
3. Remove the access cover at the back of the grill.
A
A. Access Cover
4. Using a Phillips screwdriver, remove the screws holding the
spider guard to the burner.
5. Use 24 mm wrench to remove the orifice nut.
A
A. Orifice Nut.
6. Take out the orifice support, and then use a 6 mm socket
and wrench or 6 mm nut driver to remove the LP orifice at
the end of the supply pipe. Replace with Natural gas
orifice.
A
B
IMPORTANT: Check that the orifice is properly installed inside
of supply pipe.
A. Orifice Support
B. Orifice
21