Kohler K-1914 Guide D'installation page 34

Trim Cap Cover
Install the trim caps.
19. Install the Trim Caps and Access Panel
All Installations
Secure the wall trim caps to the studs.
Align the wall trim cap nailing-in flange with the bath nailing-in flange.
Secure the wall trim cap to the studs using nails.
Install the trim cap covers over the wall trim caps using the magnets.
Attach the access panel using the attached fasteners. If the access panel does not align correctly, go
to "Optional Brush Seal Adjustments and Access Panel Bracket" below.
Check Door Operation
Recheck the door movement, using one finger to move the door up and down.
When properly adjusted the door should move up and down using one finger.
Adjust as needed ("Optional Brush Seal Adjustments and Access Panel Brackets").
Repeat until the door operates smoothly.
Optional Brush Seal Adjustments and Access Panel Brackets
NOTE: The brush seal, located on the bottom of the door, is designed to disperse water released when the
seal deflates, eliminating splashing beyond the drip tray.
If the seal is adjusted incorrectly water may splash beyond the drip tray or it may interfere with the access
panel.
1128535-2-B
Wall Trim Cap
Access Panel
Mounting Bracket
34
Install the access panel.
Brush Seal
Kohler Co.