Kohler K-1914 Guide D'installation page 22

Install Mounting Brackets
12. Install the Mounting Brackets and Pulley Assemblies
Installations Requiring Disassembly Only
NOTE: These steps are not required if the mounting brackets and pulley assemblies were not removed in a
previous step. If the mounting brackets and pulley assemblies were not removed, proceed to the "Install
the Door " section.
Install the Mounting Brackets
Align a mounting bracket with the holes in the bath.
Use the four provided blue screws to secure the mounting bracket to the bath.
Adjust the mounting bracket so it is centered in the slots or out as far as the slots allow.
Tighten the screws.
Reconnect the limit switch wire.
1128535-2-B
Mounting Bracket
Install Pulley Assemblies
Slot
Blue
Screw
22
Pulley
Assembly
Slot
Red
Screw
Kohler Co.