Ryobi RY40301 Manuel D'utilisation page 14

OPERATING TIPS
 Never point the spray end of the wand at yourself or
others.
 Avoid spraying on windy days. Spray can be accidentally
blown onto plants or objects that should not be sprayed.
WARNING:
To avoid serious personal injury, always remove the bat-
tery pack from the tool when cleaning or performing any
maintenance.
WARNING:
Always wear eye protection with side shields or goggles
marked to comply with ANSI Z87.1. Failure to do so could
result in fluids entering your eyes resulting in possible
serious injury.
WARNING:
When servicing, use only identical replacement parts.
Use of any other parts may create a hazard or cause
product damage.
NOTICE:
Periodically inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps,
etc. Tighten securely all fasteners and caps and do not
operate this product until all missing or damaged parts
are replaced. Please contact customer service or a quali-
fied service center for assistance.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
OPERATION
 Never spray in the direction of people or animals; always
 Never smoke, eat, or drink while operating the sprayer.
 Especially in warmer weather, use sprayer in the early
MAINTENANCE
Do not at any time let brake fluids, gasoline, penetrating
oils, etc., come in contact with plastic parts. Chemicals
can damage, weaken, or destroy plastic which may result
in serious personal injury.
CLEANING THE UNIT
See Figure 12.
Always store and dispose of chemicals properly. Disposal
of contaminated rinse water should be performed accord-
ing to local ordinances and bylaws.
DRAINING THE TANK
If there is any liquid left in the tank after spraying, the tank
should be drained before cleaning.
 Remove the battery pack.
 Unscrew the cap and remove it from the tank.
 Remove the strainer from the tank.
 Drain the contents of the tank through the fill area.
 Review chemical SDS sheet how best to secure and store
CLEANING THE SPRAYER, TANK AND SPRAY LINES
 Fill the tank about one-third full with clean water. A small
 Replace the tank cap and tighten securely.
10 — English
spray downwind.
morning or late afternoon. Excessive heat can evaporate
the mist before it settles.
WARNING:
WARNING:
your chemical solution when not in use.
NOTE: Drain the contents back into the original container.
Do not store chemicals in the tank.
amount of mild household detergent may be added.
NOTE: Never use flammable chemicals or abrasive
cleaning agents to clean the tank.