Ryobi RY40301 Manuel D'utilisation page 11

CONNECTING THE SPRAY WAND TO THE
TRIGGER HANDLE
See Figure 2.
 Insert the spray wand into the handle as shown.
 Slide the o-ring down until it touches the handle.
 Thread the cap onto the handle and tighten securely.
 Pull on the spray wand to be certain it is properly secured.
 When not in use, place the assembled trigger handle into
the handle storage area on the cap.
ATTACHING A NOZZLE
See Figure 3.
Four nozzles are provided with the backpack sprayer. The
cone nozzle comes already attached to the 45° elbow. Each
nozzle can be used with or without the elbow.
 Thread the elbow onto the end of the spray wand. Hand
tighten.
WARNING:
Do not allow familiarity with the product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields or goggles
marked to comply with ANSI Z87.1. Failure to do so could
result in fluids entering your eyes resulting in possible
serious injury.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.
WARNING:
Use safety equipment. Protect your eyes, skin, and lungs
while mixing, filling, spraying, and cleaning. Failure to do
so may result in serious personal injury and damage to
property.
ASSEMBLY
 Attach a nozzle by threading it onto the elbow. Make sure
the connection is secure. Do not overtighten.
 If necessary, loosen the nut holding the spray wand to
the trigger handle. Rotate the wand until it is aligned with
the nozzle pointing downward and ready for use.
 Hand tighten. Do not overtighten.
ATTACHING THE HOSE
See Figure 4.
The hose comes preassembled to the trigger handle. If it
becomes loose, follow the instructions below.
 Slide the nut on the hose away from the hose end.
 Insert the hose into the handle as shown.
 Slide the nut over the hose and onto the handle. Hand
tighten. Do not overtighten.
OPERATION
NOTICE:
Before each use, inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps,
etc. Tighten securely all fasteners and caps and do not
operate this product until all missing or damaged parts
are replaced. Please contact customer service or an
authorized service center for assistance.
APPLICATIONS
You may use this product for the purpose listed below:
 For use with most consumer grade home and garden
chemicals such as insecticides, fungicides, weed killers
and fertilizers
Improper application of chemicals or solutions can result
in SEVERE INJURY or DEATH. Follow all CDC and EPA
guidelines. Follow the chemical manufacturer's safety
instructions and guidelines listed on the SDS sheet.
7 — English
WARNING: