Beko HNT 61311 X Mode D'emploi page 11

Using the appliance
3
Bulb
Bulb Power
Holder / Socket
Bulb Voltage
Size
ILCOS Code
Luminous flux
Correlated colour tem-
perature
This product contains a light source of
energy efficiency class "F".
• Candle type led lamp is used in this
product.
• When changing the lamp, max. 4 W
lamp should be used.
• Before replacing the light
bulbs, disconnect the power
supply of the hood.
A
• Do not touch the light bulbs
when they are hot.
• Be careful not to touch the
replaced light bulb directly
with hands.
C
You may procure lamps from
Authorised Service Agents.
3.5 Operation with chimney
connection
Vapour is extracted thro-
•
ugh the flue duct, which
is fastened to the connec-
tion head on the hood.
• The diameter of the flue duct must be
Cooker Hood / User Manual
4 W
E14
220 - 240 V
35x100 mm
DRBB/F-4-220-
240-E14-35/100
400 ml
3000 K
the same as the connection ring. In ho-
rizontal settings, the pipe has to have
a slight upward slope (around 10º) so
that the air can exit the room easily.
3.6 Operation without chimney
connection
Air is filtered through the
•
carbon filter and recircu-
lated in the room. Carbon
filter is used when it is im-
possible to use a flue in
the house.
• In flueless use, remove the flaps inside
the flue adapter.
• Remove the aluminum grease filter. To
install the carbon filter, fit the filter to the
tabs by centring it on the plastic piece on
both sides of the fan body. tighten it by tur-
ning right or left.
• Replace aluminum grease filter.
11 / EN