Publicité
Les langues disponibles
Les langues disponibles
Flying instructions
Only fly on calm days or indoors. Check the centre of
gravity before each flight and make sure all parts are
fixed properly. Switch on the transmitter and make sure
that the Micro controller 2000 (2-channel) is off, resp.
the throttle is in minimum position. Connect the
powerpack. Do not extend the transmitter antenna and
walk away from the model. Someone should help you
to hold the model. Although the antenna is not pulled
out there may be no malfunction malfunction within a
range of 30meters (100 ft)
be executed properly. Now you may pull out the
antenna.
The Speedswitch only allows starting by hand. Push
the Speedswitch forward and carefully move the model
ahead. Watch your model. If it falls, pull slightly on your
stick until the Bleriot III starts climbing. Use the
The Micro switch 2G allows you to start from the ground.
Put the model down, open the throttle and after a few
meters the BLERIOT III is climbing. Do the trimming of
the model as described before.
When the powerpack runs down, the model will slowly
fall. If necessary, correct by pulling the stick and look for a
suitable place to land in time. Even at minimum speed
the BLERIOT III is easy to fly.
Important: This product may be used only in the way it is
designed for and it cannot compensate poor quality
product it cooperates with. Also it cannot compensate for
poor model setup and maintenance, design faults or
steering mistakes.
Guarantee, warranty and liability according to our
general conditions of sale.
All manuals and user guides at all-guides.com
.
and all instructions should
Publicité
