Husqvarna 215iHD55 Manuel D'utilisation page 15

Maintenance
Do a check of the connections between the battery and the product. Do a check
of the connection between the battery and the battery charger.
Examine that the sweeper is not damaged.
To examine the battery and the battery
charger
1. Examine the battery for damages, for example
cracks.
2. Examine the battery charger for damages, for
example cracks.
3. Make sure that the connection cord of the battery
charger is not damaged and that there are no cracks
in it.
To clean the product, the battery and
the battery charger
1. Clean the product with a dry cloth after use.
2. Clean the battery and battery charger with a dry
cloth. Keep the battery guide tracks clean.
3. Make sure that the terminals on the battery and the
battery charger are clean before the battery is put in
the battery charger or the product.
To examine the blade
1. Clean the blade from unwanted materials with an
anti corrosion cleaning agent before and after you
use the product.
2. Examine the edges of the blade for damages and
deformation.
Keypad
LED screen
The error LED flashes.
The product does not start.
The error LED comes on with red
light.
1980 - 002 - 15.11.2023
3. Use a file to remove burrs on the blade.
4. Make sure that the blades move freely.
To clean and lubricate the blades
1. Clean the blades from unwanted materials before
and after you use the product.
2. Lubricate the blades before long periods of storage.
Note:
information about recommended cleaning agents and
lubricants.
To lubricate the gear
Apply grease to the gear housing if the gear has been
disassembled by an approved servicing dealer.
• Use Husqvarna special grease. Speak to your
servicing dealer for more information about
recommended grease.
• Only use a small quantity of a special high quality
grease.
Troubleshooting
Possible faults
Overload
Temperature deviation
Push the power trigger and press the
start button at the same time.
It is necessary to do servicing on the
product
Before
Weekly
use
X
Speak to your servicing dealer for more
CAUTION:
Do not fill the gear
housing fully.
Possible solutions
The cutting attachment cannot move
freely. Release the cutting attach-
ment.
Let the product cool down.
Release the power trigger and stop
the product.
Speak to your service dealer.
Monthly
X
15