Install The Mulch Plug; Install The Side Discharge Chute; Set The Cutting Height; Install The Battery Packs - GreenWorks MO48L4213 Manuel D'utilisation

EN
4. Hold the the grass catcher (11) by its handle and engage
the hooks (18) on the door rod (19).
5. Close the rear discharge door.
7.5

INSTALL THE MULCH PLUG

1. Remove the grass catcher.
2. Open the rear discharge door (6) and hold it.
3. Hold the mulch plug (13) by its handle and fit it in the
discharge chute.
4. Close the rear discharge door.
7.6 INSTALL THE SIDE DISCHARGE
CHUTE
20
12
When you use the side discharge chute,
• Do not install the grass catcher.
• Keep the mulch plug installed.
1. Open the side discharge door (20) and hold it.
13
21
CAUTION
English
2. Line up the recesses of the side discharge chute (12)
below the pivot (21).
3. Close the side discharge door.
7.7

SET THE CUTTING HEIGHT

The machine can be set to different cutting height.
6
1. Pull the height adjustment lever (7) rearward to increase
the cutting height.
2. Pull the height adjustment lever forward to decrease the
cutting height.
7.8

INSTALL THE BATTERY PACKS

THIS MOWER MUST HAVE TWO BATTERIES TO RUN!
29
10
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the engine stops before
you install or remove the battery pack.
• Read, know, and follow the instructions in the battery
and charger manual.
10
7
8
28
30
WARNING