Unfold And Adjust The Handle; Install The Grass Catcher; Install The Mulch Plug; Set The Blade Height - GreenWorks 2517302 Manuel D'utilisation

EN
6.2 UNFOLD AND ADJUST THE
HANDLE
Figure 2.
1. Pull up and back the upper handle to lift the handle
into operation position. Make sure that the handles
click into position correctly.
2. Tighten the lower handle with the quick-release
levers on the two sides.
3. Tighten the upper handle with the cam locks on the
two sides.
Make sure that the two handles are in the same
position.
Do not make damage to the cables when you fold or
unfold the handle.
6.3

INSTALL THE GRASS CATCHER

Figure 3.
1. Remove the mulch plug.
2. Open the rear discharge door and hold it.
3. Hold the the grass catcher by its handle and engage
the hooks on the slots.
4. Close the rear discharge door.
6.4

INSTALL THE MULCH PLUG

Figure 4.
1. Remove the grass catcher.
2. Open the rear discharge door and hold it.
3. Hold the mulch plug by its handle and fit it in the
discharge chute.
4. Close the rear discharge door.
6.5

SET THE BLADE HEIGHT

The machine can be set to different blade heights.
Figure 5.
1. Pull the height adjustment lever rearward to
increase the blade height.
2. Pull the height adjustment lever forward to decrease
the blade height.
6.6

INSTALL THE BATTERY PACK

Figure 6.
NOTE
WARNING
English
• If the battery pack or charger is damaged, replace
the battery pack or the charger.
• Stop the machine and wait until the engine stops
before you install or remove the battery pack.
• Read, know, and do the instructions in the battery
and charger manual.
1. Open the battery door.
2. Align the lift ribs on the battery pack with the
grooves in the battery compartment.
3. Push the battery pack into the battery compartment
until the battery pack locks into place.
4. When you hear a click, the battery pack is installed.
5. Close the battery door.
6.7

REMOVE THE BATTERY PACK

Figure 6.
1. Open the battery door.
2. Push and hold the battery release button.
3. Remove the battery pack from the machine.
7

OPERATION

Wear eye protection during operation.
7.1

START THE MACHINE

Figure 7.
1. Push and hold the start button.
2. While you hold the start button, pull the bail switch in
the direction of the handle bar.
3. Release the start button to start the machine.
7.2

STOP THE MACHINE

Figure 7.
1. Release the bail switch to stop the machine.
Wait until the blades fully stop before you start the
machine again. Do not quickly turn the machine off
and on.
Always remove the battery pack after you complete
the work.
7.3

EMPTY THE GRASS CATCHER

1. Stop the machine.
6
WARNING
WARNING
WARNING
WARNING