Worx WG772E Mode D'emploi page 11

equipment when barefoot or
wearing open sandals;
b) Thoroughly inspect the area
where the equipment is to be
used and remove all objects
which can be thrown by the
machine;
c) Before using, always visually
inspect to see that the
blades, blade bolts and cutter
assembly are not worn or
damaged. Replace worn or
damaged blades and bolts
in sets to preserve balance;
Replace damaged and
unreadable labels.
d) On multi-bladed machines,
take care as rotating one
blade can cause other blades
to rotate.
OPERATION
a) mow only in daylight or in
good artificial light;
b) avoid operating the
equipment in wet grass,
where feasible;
c) always be sure of your footing
on slopes;
d) walk, never run;
e) for wheeled rotary machines,
mow across the face of
slopes, never up and down;
f) exercise extreme caution
when changing direction on
slopes;
g) do not mow excessively steep
slopes;
h) use extreme caution when
reversing or pulling the
lawnmower towards you;
i) stop the blade(s) if the
Cordless Lawn Mower
All manuals and user guides at all-guides.com
lawnmower has to be tilted
for transportation when
crossing surfaces other than
grass, and when transporting
the lawnmower to and from
the area to be mowed;
j) never operate the lawnmower
with defective guards, or
without safety devices, for
example deflectors and/or
grass catchers, in place;
k) switch on the motor carefully
according to instructions and
with feet well away from the
blade(s);
l) do not tilt the lawnmower
when switching on the motor,
except if the lawnmower has
to be tilted for starting In this
case, do not tilt it more than
absolutely necessary and lift
only the part which is away
from the operator;
m) do not put hands or feet near
or under rotating parts. Keep
clear of the discharge opening
at all times;
n) not to touch the blades before
the disabling device has been
removed and the blades have
come to a complete stop;
o) Do not start the lawnmower
when standing in front of the
discharge opening.
p) Do not transport the
lawnmower while the power
source is running.
q) Stop the lawnmower,
and remove the disabling
device. Make sure that all
moving parts have come to a
complete stop.
11
EN