Bluetooth Status Indications; Installing The Microphone; Pairing; Searching From The Bluetooth Device - Sony XAV-601BT Mode D'emploi

Bluetooth status indications

None: Bluetooth signal is off.
Lit: Bluetooth signal is on.
None: No device is connected for
audio streaming.
Flashing: Connection is in progress.
Lit: A device is connected.
None: No cellular phone is connected
for handsfree calling.
Flashing: Connection is in progress.
Lit: A cellular phone is connected.
Indicates the signal strength status of
the connected cellular phone.
Indicates the remaining battery status
of the connected cellular phone.
None: No unread SMS messages
Lit: Unread SMS message(s)

Installing the microphone

To capture your voice during handsfree calling,
you need to install the microphone (supplied).
For details on how to connect the microphone,
refer to the supplied "Installation/Connections"
guide.

Pairing

Pairing is required only the first time you connect
to a Bluetooth device (cellular phone, etc.).*
For details, refer to the manual of the Bluetooth
device.
* If you delete the device registration from this unit,
you need to perform pairing again.
Tip
You can pair up to 9 devices.
Searching from the Bluetooth
device
The procedure to search for this unit from the
other Bluetooth device is explained below.
1
Press (HOME), then touch "Settings."
2
Touch , and move the scrollbar up
and down.
3
Touch "Bluetooth Connection," then
set the signal to "ON."
The Bluetooth signal of this unit is activated.
4
Touch "Pairing >."
This unit is ready to be detected by the other
Bluetooth device.
5
Operate the Bluetooth device to
search for this unit.
A device list appears on the display of the
device. This unit is displayed as "Sony
Automotive."
DR-BT30Q
Sony
Automotive
XXXXXXX
6
If passkey* input is required on the
display of the device, input "0000."
XXXX
This unit and the Bluetooth device memorize
each other's information, and when pairing is
made, this unit is ready for connection to the
device.
Input passkey.
"0000"
37