Setting The Clock; Preparing The Remote Commander; Detaching The Front Panel; Attaching The Front Panel - Sony XAV-601BT Mode D'emploi

Masquer les pouces Voir aussi pour XAV-601BT:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

• For details on setting the character encoding,
see page 50.
• For details on setting the display language, see
page 50.
Note
Some characters may not be displayed correctly,
depending on the language/country/region.

Setting the clock

The clock uses a 12-hour indication.
1
Press (HOME), then touch "Settings."
2
Touch
, then touch "Clock Adjust."
The setting display appears.
3
Set the hour and minute.
For example, to set to 8:30, touch "0830."
4
Touch "AM" or "PM."
5
Touch "OK."
The setting is complete.
To activate/deactivate the CT function, touch
"CT" in step 3. (page 50)
To delete an entered number, touch "Clear."
To return to the previous display, touch
Notes
• The CT function may not work even though an RDS
station is being received.
• There may be a difference between the time set by
the CT function and the actual time.
Preparing the remote
commander
Before using the remote commander for the first
time, remove the insulation film.
16

Detaching the front panel

You can detach the front panel of this unit to
prevent theft.
Caution alarm
If you turn the ignition switch to the OFF
position without detaching the front panel, the
caution alarm will sound for a few seconds.
The alarm will only sound if the built-in
amplifier is used.
1
Press and hold (SOURCE/OFF).
The unit is turned off.
2
Press
3
1Lift the left side of the front panel.
2Pull it off towards you.
Notes
.
• Do not drop or put excessive pressure on the front
panel and display window.
• Do not subject the front panel to heat/high
temperature or moisture. Avoid leaving it in a parked
car or on a dashboard/rear tray.
• Do not detach the front panel during playback of the
USB device, otherwise USB data may be damaged.

Attaching the front panel

Engage part A of the front panel with part B of
the unit, as illustrated, and push the left side into
position until it clicks.
Note
Do not put anything on the inner surface of the front
panel.
.

Publicité

Table des Matières
loading

Table des Matières