Husqvarna 535RX Manuel D'utilisation page 27

• Use a 5.5 mm round file with a file holder.
• Hold the file at an angle of 15°.
• Sharpen one tooth of the saw blade to the right and
the next tooth to the left, see the illustration.
The engine does not start
Check
Stop switch.
Starter pawls.
Fuel tank.
Spark plug.
1069 - 009 - 13.06.2023
15˚
Troubleshooting
Possible cause
The stop switch is in the stop posi-
tion.
The starter pawls cannot move free-
ly.
Incorrect fuel type.
The spark plug is dirty or wet.
The spark plug electrode gap is in-
correct.
The spark plug is loose.
Note:
Sharpen the edges of the teeth with a flat
file if the blade is heavily worn. Continue to sharpen
with a round file.
• Sharpen all edges equally to keep the blade
balanced.
• Adjust the blade set to 1 mm with the recommended
setting tool. Refer to the instructions that come with
the blade.
WARNING:
that is damaged. Do not try to make a bent
or twisted blade straight and use it again.
Procedure
Let an approved service agent re-
place the stop switch.
Remove the starter cover and clean
around the starter pawls. See
uct overview on page 2 .
Let an approved service agent help
you.
Drain the fuel tank and fill with cor-
rect fuel.
Make sure that the spark plug is dry
and clean.
Clean the spark plug. Make sure that
the electrode gap is correct. Make
sure that the spark plug has a su-
pressor.
Refer to technical data for correct
electrode gap.
Tighten the spark plug.
Always discard a blade
Prod-
27