Table des Matières
Publicité
ENGLISH
HYDRAULIC CUTTING HEAD
1. GENERAL CHARACTERISTICS
– Application Range: suitable for cutting steel ropes and conductors with max. overall
diameter of 40 mm (1-9/16"), see TABLE page 21.
– Max operating pressure: ......................................................... 700 bar
– Dimensions: length .................................................................. 311 mm
width .................................................................... 100 mm (3.9 in.)
– Weight: ...................................................................................... 4,0 kg
2. INSTRUCTIONS FOR USE
2.1) Setting
(Ref. to Fig. 4)
The head is equipped with a "self-lock" quick male coupler suitable for connection to a
hydraulic, pneumatic or electric pump from the Cembre range.
– Insert the conductor between the blades at the desired cutting point. For a running
conductor, remove the locking pin (27) and open the tool head.
Fully retract the lower blade (12) before attempting to open the tool head.
– With the conductor on the lower blade (12), close the tool head and fully insert the lock-
ing pin (27).
Before carrying out further cutting operations make sure the locking pin (27) is
completely inserted: a partial insertion may damage the tool head.
2.2) Blade advancement
Operate the pump to advance the lower blade.
Make sure the blades are exactly positioned on the desired cutting point; otherwise retract
the lower blade, as § 2.4 and re-position the cutting head.
2.3) Cutting
Continue operating the pump to close the blades and progressively cut the conductor.
2.4) Blade opening
To open the blades, fully discharge the oil pressure from the pump.
TC04
(10,000 psi)
(12.2 in.)
(8.8 lbs)
27
12
FIG. 3
UPPER BLADE REPLACEMENT
CHANGEMENT LAME SUPERIEURE
GEGENMESSERWECHSEL
CAMBIO CUCHILLA SUPERIOR
CAMBIO LAMA SUPERIORE
3
20
17
13
16
26
02
17
16
14
Publicité
Table des Matières
